EasyWood

Multiple Holes

This command enables to draw a series of holes; just set the diameter and the depth, then define the central point of the first hole, the distance between the hole centres (Centre-to-centre Distance) and the target end point or the total number of holes to insert.

When the end point of the multiple drilling is requested, one single number can also be entered; in this case EasyWOOD will require the rotation angle too and will enter the number of holes requested while following the given direction.

By selecting Through Hole, EasyWOOD creates a series of holes that go through the whole solid geometry.

To define an inclined hole it is necessary to define a layer on an inclined plane and then insert the hole on this plane.

 

Créé avec HelpNDoc Personal Edition: Écrire des livres électronique Kindle